ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 192)

Dimension GS-3012F Gigabit Ethernet Switch
28-18 Introduction to CLI
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
timesync Sets the time server protocol.
server Sets the IP address of your time
server.
loginPrecedence
LocalRADIUS |
RADIUSOnly>
Select which database the switch
should use (first) to authenticate a
user.
igmp-snooping Enables IGMP snooping.
bcp-
transparency Enables Bridge Control Protocol
Transparency.
queue level <0-7>
priority <0-7>
Sets the priority level-to-physical
queue mapping.
storm-control Enables broadcast storm control
on the switch.
bandwidth-
control Enables bandwidth control.
mac-aging-time <10-3000> Sets learned MAC aging time.
snmp-server [contact
contact>] [location
]
Sets the geographic location and
the name of the person in charge
of this switch.
get-community Sets the get community.
set-community Sets the set community.
trap-community Sets the trap community.
trap-destination Sets the IP addresses of up to four
stations to send your SNMP traps
to.
logins username
password Configures up to four read-only
login accounts.
service-control icmp Allows ICMP access to the switch
such as pinging and tracerouting.
snmp Allows SNMP management.
http
number>
Allows HTTP access on the
specified service port and defines
the timeout period.
telnet
number>
Allows Telnet access on the
specified service port.
ftp Allows FTP access on the
specified service port.