ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 193)

Dimension GS-3012F Gigabit Ethernet Switch
Introduction to CLI 28-19
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
ssh Allows SSH access on the
specified service port.
https
number>
Allows HTTPS access on the
specified service port.
remote-
management start-addr
end-addr
service
|icmp|snmp>
Specifies a group of trusted
computer(s) from which an
administrator may use a service to
manage the switch.
admin-password Changes the administrator
password.
default-
management band> Specifies through which traffic flow
the switch is to send packets.
ssh known-hosts
ip> <1024|ssh-
rsa|ssh-dsa>
Adds a remote host to which the
switch can access using SSH
service.
https cert-regeneration Re-generates a certificate.
timeout <0-65535> Sets the HTTPS timeout period.
multi-login Enables multi-login.
dhcp-relay Enables DHCP relay.
helper-address
[svr2_ip]
[svr3_ip]
Sets the IP addresses of up to 3
DHCP servers.
option Allows the switch to add DHCP
relay agent information.
information Allows the switch to add system
name to agent information.
28.9.4 config-vlan Commands
The following table lists the config-vlan commands in configuration mode.
Table 28-4 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
vlan <1-4094> Creates a new VLAN group.
name Specifies a name for identification
purposes.
normal Specifies the port(s) to dynamically join
this VLAN group using GVRP