Toshiba E-STUDIO 351C - Manual (Page 305)

3. Printing
Printing Guide — Printing from UNIX 305
In a job, if this value is LT, and in PDL too the data is for LT paper size, this will result in
a scaled booklet on Letter paper. In a job, if this value is A3, and in PDL the data is for
A4 paper size, this will result in a tiled booklet on A3 paper.
When the Booklet Mode options is selected, the paper size is automatically set to the
same size as for Booklet Mode. This function is only available for A3, A4, B4, Letter and
Ledger paper sizes.
If booklet mode is selected, then duplexing is also selected automatically (sduplex).
Setting duplexing separately can override the booklet mode setting for duplexing.
Example: The command to select the letter size paper for booklet printing mode is
“lp –o booklet=letter filename”.
— Page Layout
The booklet mode page layout can be selected using the following options.
booklet=ledger ld
LD Select ledger size paper for booklet printing mode.
booklet=folio folio-japan Select folio size paper for booklet printing mode.
booklet=A3 a3 Select A3 size paper for booklet printing mode.
booklet=A5 a5 Select A5 size paper for booklet printing mode.
booklet=B4 b4
B4-JIS
b4-jis Select JIS B4 size paper for booklet printing mode.
booklet=B5 b5
B5-JIS
b5-jis Select JIS B5 size paper for booklet printing mode.
booklet=
computer co
CO Select computer size paper for booklet printing mode.
booklet=legal13 lg13
LG13 Select legal-13 size paper for booklet printing mode.
booklet=SQ85 sq85
letter-square Select 8.5 inch square size paper for booklet printing
mode.
booklet=8K 8k Select 8K size paper for booklet printing mode.
booklet=16K 16k Select 16K size paper for booklet printing mode.
Option Value Alternate Value Description
left2right=off OFF Select right to left page layout for booklet printing mode.
This value decides the layout of the pages in the book-
let.
If this value is OFF then the layout of pages is Right to
Left as shown in the figure below.
Option Value Alternate Value Description