P.170 "creating a print queue manually – Toshiba E-STUDIO 351C User Manual
Page 170
2. Installing Client Software
170
Printing Guide — Installing Client Software for UNIX
2.
Enter the following command:
est451cadd
SUPPLEMENTS:
•
This command creates a print queue using the system’s lpadmin command. It also
creates a configuration file that has the destination IP address or host name. Use
the configuration file to change print queue parameters.
•
The lpadmin command stores the printer interface file in the /etc/lp/interfaces direc-
tory in a file with the same name as the print queue. The configuration file is stored
in the /etc/lp/interfaces directory in a file named
•
Under Linux, the printtool (or equivalent) utility must be used to add the printer into
the lp printing system after executing the est bwadd command.
Creating a Print Queue Manually
You can also configure the print queue by adding a remote printer manually.
The procedure varies depending on the operating systems.
P.170 "Creating a print queue manually on Solaris"
P.171 "Creating a print queue manually on HP-UX"
P.171 "Creating a print queue manually on IBX AIX"
P.172 "Creating a print queue manually on Linux"
P.173 "Creating a print queue manually on OpenUNIX"
Creating a print queue manually on Solaris
1.
Log on to the root account.
2.
Open your Linux/UNIX editor.
3.
Create the following file.
/etc/lp/interfaces/
4.
Add a line as below in the
dest=
5.
Save the file.
6.
Enter the following command:
chmod +x
7.
Enter the following command:
chown lp:lp
8.
Enter the following command:
lpadmin -p
-i /usr/lib/lp/model/net_est451c
9.
Enter the following command:
accept
10.
Enter the following command:
enable