Configuring the options automatically, P.196 "configuring the options automatically – Toshiba E-STUDIO 351C User Manual
Page 196
3. Printing
196
Printing Guide — Printing from Windows
2.
Display the [Configuration] tab and set the following options.
Pedestal — This sets whether the drawer 3, drawers 3 & 4, or large capacity
feeder (not available for some countries or regions) are installed.
Finisher — This sets whether or not optional finisher is installed.
Hole Punch Unit — This sets whether or not optional hole punch unit is
installed.
Drawer 1/Paper Type — Select the paper size and paper type of paper that is
loaded in the 1st Drawer.
Drawer 2/Paper Type — Select the paper size and paper type of paper that is
loaded in the 2nd Drawer.
Drawer 3/Paper Type — Select the paper size and paper type of paper that is
loaded in the 3rd Drawer when it is installed.
Drawer 4/Paper Type — Select the paper size and paper type of paper that is
loaded in the 4th Drawer when it is installed.
Large Capacity/Paper Type — Select the paper size and paper type of paper
that is loaded in the Large Capacity Feeder when it is installed.
Bypass Feeder — Select the paper type of paper that is loaded in the Stack
Feed Bypass.
Memory — Select the size of memory.
NOTE:
LCF is not available for some countries or regions.
SUPPLEMENT:
For more information about each item, see descriptions about the Configuration Tab.
3.
Click [Apply] and [OK] to save settings.
— Configuring the Options Automatically
The following describes an instruction on Windows 2000. The procedure is the same
when other versions of Windows are used.