Texas Instruments MSC1210 - Manual (Page 290)

8052 Instruction Set
E-6
ANL Bitwise AND
Syntax ANL operand1,operand2
Instructions OpCode Bytes Cycles Flags
ANL direct,A 0x52 2 1 None
ANL direct,#data8 0x53 3 2 None
ANL A,#data8 0x54 2 1 None
ANL A,direct 0x55 2 1 None
ANL A,@R0 0x56 1 1 None
ANL A,@R1 0x57 1 1 None
ANL A,R0 0x58 1 1 None
ANL A,R1 0x59 1 1 None
ANL A,R2 0x5A 1 1 None
ANL A,R3 0x5B 1 1 None
ANL A,R4 0x5C 1 1 None
ANL A,R5 0x5D 1 1 None
ANL A,R6 0x5E 1 1 None
ANL A,R7 0x5F 1 1 None
ANL C,bitAddr 0x82 2 1 C
ANL C,/bitAddr 0xB0 2 1 C
ANL does a bitwise AND operation between operand1 and operand2, leaving
the resulting value in operand1. The value of operand2 is not affected. A logical
AND compares the bits of each operand and sets the corresponding bit in the
resulting byte only if the bit was set in both of the original operands. Otherwise,
the resulting bit is cleared.
See also: ORL, XRL