Toshiba Magnia Z300 - Manual (Page 89)

Installing and Removing Hardware
Removing and replacing the server panels
67
Sliding the server (Rack Type) out of the rack
Slide the server out of the rack in the procedure described below,
while referring to “Before starting operation” on page 48.
1 If the server is running, shut it down and switch off the power.
2 Switch off all the peripheral units connected with the server.
3 Unplug the power cable of the server from the AC outlet or
UPS (uninterruptible power supply).
4 Unplug all the cables from the server.
5 Loosen the four claw screws which fix the Base Assembly and
draw out the Base Assembly.
Drawing out the Base Assembly
When turning the claw screws, remove the front panel so that you
do not catch your fingers.
6 Remove the screw (M3) fixing the Base Assembly to the
server.
Claw
screw