Switch setting, Hardware setup information, 1 disconnect the ac power cable – Toshiba Magnia Z300 User Manual

Page 254: 5 turn on the server, 6 disconnect the ac power cable, Appendix c: switch setting

232

Switch Setting

Hardware setup information

Perform the following operations if the hardware setup informa-
tion is to be forcibly returned to the standard settings (CMOS
Clear):

1 Disconnect the AC power cable.

2 Remove the server panels, power supply unit and board for

wireless card.

3 Set the jumper switch PJ47 on the motherboard to 1-2 short.

PJ47:

1-2 short ... Clears the hardware data settings.
3-4 short... Standard (Defined data)

4 Install the board for wireless card, power supply unit and

server panels, and connect the AC power cable.

5 Turn on the server.

CMOS is cleared and the power is automatically turned off.

6 Disconnect the AC power cable.