beautypg.com

5 input slot number “10005” to ce100b parameters, Installation of multi cpu options, Procedure after installation of the netware – Toshiba Magnia Z300 User Manual

Page 212: Setup of the raid controller utility

background image

Installing Software
NetWare

190

4 When the driver list appears, select the following driver.

5 Input slot number “10005” to CE100B Parameters.

Proceed with installing operation, following the instructions that
appear on the screen.

Installation of Multi CPU Options

When the system is used in a 2CPU configuration, follow the pro-
cedure below to install the multi CPU options after installing
NetWare.

1 Start up NetWare, and select “Multi CPU Options” in the

Install screen.

2 Select the following driver from the list of drivers displayed at

“Select platform support module”.

Reboot the unit to enable multi CPU options.

Procedure after installation of the NetWare

Setup of the RAID Controller Utility

If the RAID controller is connected with the server, be sure to set
up the “MegaRAID Manager” that is a RAID Controller Utility
after installing NetWare. If the MegaRAID Manager is not set up,
the system cannot be recovered from a disk trouble during
operation.

See “MegaRAID Software Guide” for details of the MegaRAID
Manager.

|| CE100B.LAN || Intel(R) PRO PCI Adapter(CHSM spec 1.11)||

|| IANS.LAN || Intel(R) Advanced Network Services Driver ||

MPS14.PSM | Platform Support Module for Intel

MPS Compliant Systems