Tascam 2488neo - Manual (Page 60)

60
TASCAM 2488neo
7 − Recorder
COPY
®
PASTE
This function takes the section of a track or tracks marked
by the IN and OUT points, copies it, and places it at the TO
point on the chosen track or tracks. The original source is
left unchanged.
OUT IN TO
OUT IN TO
The copy operation overwrites anything which is already
recorded at the destination. The destination is the same
length as it was before the operation.
You can copy the section more than once in one operation.
You can change the following values:
Src.Trk This sets the source track or tracks from which the
section is copied. Choose 1 through 24 to select an individ-
ual track. Choose 1/2, 3/4, 5/6 etc. to select a pair of tracks.
Choose 1-24 to select all tracks.
Dst. Trk This sets the destination track or tracks to which
the selected section is pasted. What you can select here
depends on what you have selected for the source track.
If you have selected a single track, you can select tracks 1
through 24 here. If you have selected a pair of tracks (for
instance, 1/2), you can only select track pairs here. If you
have selected all tracks (1-24), then 1-24 is the only option
available to you here.
Times This is the number of times that the selected sec-
tion is pasted into the destination track or tracks. You can
set this value from 1 to 99.
Press YES/ENTER to perform the operation or NO/EXIT to
leave this screen.
COPY FROM
®
TO
This function copies the audio material from between the
IN and OUT points on the copy source track and pastes it
to the copy destination track. In this operation, the FROM
point is set within the section to be copied. When this sec-
tion is pasted, this FROM point is relocated to the destina-
tion TO point. This function is useful when you need to
align a specific moment in a section, rather than the begin-
ning or end of the section, to a specific time.
OUT FROM IN TO
OUT IN TO
The copy source does not change after this operation.
This operation overwrites anything that is recorded at the
destination. The length of the copy destination track does
not change.
This operation has the three following parameters:
Src.Trk This selects the source track from which the
section is copied. Choose 1 through 24 to select an indi-
vidual track. Choose 1/2, 3/4, etc. to select a pair of tracks.
Choose 1-24 to select all tracks.
Dst.Trk This sets the destination track to which the selec-
tion is copied. Selection options here depend on what you
have selected for the Src.Trk. If you have selected a single
track, you can select tracks 1 through 24 here. If you have
selected a pair of tracks (for instance, 1/2), you can only
select track pairs here (1/2, 3/4, etc.). If you have selected
all tracks (1-24), then 1-24 is the only option available here.
Times This is the number of times that the selected sec-
tion is pasted into the destination track or tracks.
You can set this value from 1 to 99.
NOTE
The COPY∑PASTE operation pastes the material after
the TO point continuously without gaps, while COPY
FROM∑TO maintains the amount of time between
the FROM point and TO point when audio is pasted.
Moreover, only this function appears in the Undo list
as COPY∑PASTE.
After setting the parameters, press the YES/ENTER key to
perform the operation or the NO/EXIT key to leave this screen.