Tascam 2488neo - Manual (Page 3)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM 2488neo
3
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8 Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9 Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10 Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11 Only use attachments/accessories specified by
the manufacturer.
12 Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over.
13 Unplug this apparatus during lightning storms or
when unused for long periods of time.
14 Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Do not expose this apparatus to drips or splashes. •
Do not place any objects filled with liquids, such as •
vases, on the apparatus.
Do not install this apparatus in a confined space such •
as a book case or similar unit.
The apparatus draws nominal non-operating power from •
the AC outlet with its POWER switch in the off position.
The apparatus should be located close enough to the •
AC outlet so that you can easily grasp the power cord
plug at any time.
The main plug is used as the disconnect device, the •
disconnect device shall remain readily operable.
An apparatus with Class I construction shall be connected •
to an AC outlet with a protective grounding connection.
Batteries (battery pack or batteries installed) should •
not be exposed to excessive heat such as sunshine,
fire or the like.