Tascam 2488neo - Manual (Page 111)

15 − Appendix
TASCAM 2488neo
111
Effect
chain # Effect
NRPN Parameter Values
4 Wah (WAH)
00 15 Attack 1 – 100 = 0.1 – 10.0 (Hz)
00 16 Sense 0 – 100 = 0 – 100
00 17 (reserved)
00 18 (reserved)
00 19 Switch 0, 1 = Off, On
5 Delay (DLY)
00 20 Time 0 – 1000 = 0 - 1000 (ms)
00 21 Feedback 0 – 100 = 0 – 100
00 22 Hi Damp 0 – 100 = 0 – 100
00 23 Mix Level 0 – 100 = 0 – 100
00 24 Type 0 – 6 = OFF, Normal. Pan, Stereo, FB Mod, Gate, Reverse
00 20 Time-L 0 – 1000 (ms) *If type is Stereo only
00 26 Time-R 0 – 1000 = 0 – 1000 (ms) *If type is Stereo only
00 21 Feedback-L 0 – 100 = 0 – 100 *If type is Stereo only
00 27 Feedback-R 0 – 100 = 0 – 100 *If type is Stereo only
00 28 Threshold 0 – 100 = 0 – 100 *If type is Gate only
MIDI Program Change messages
The 2488neo can accept Program Change messages to
select an effect and to change scenes. Before a Program
Change message is sent for changing an effect, a Bank
Select message must be sent to select whether an effect will
be selected from the preset bank or from the user bank of
memories. In each case, bank 0 corresponds to the preset
memories, and bank 1 to the user bank.
Send the Bank Select messages (CC 0) on MIDI channels
1 through 8 for mic effects (see below), MIDI channel 9 for
stereo dynamics, channel 10 for the single effect, and chan-
nel 11 for the multi effect.
When selecting a mic effect, a Bank Select message should
first be sent on channel 14 to select the group of eight
channels or inputs out of which the channel is selected:
Bank 0: Mixer channels 1 though 8
Bank 1: Mixer channels 9 through 16
Bank 2: Mixer channels 17 through 24
Bank 3: Inputs A through H
The Program Change messages that are then valid are as
follows (see the tables following for details of the preset
values—the “user” messages correspond to the entry num-
ber in the library):
Mic effects (preset) Program Change 0 to 3
Mic effects (user) Program Change 0 to 99 (maximum)
Stereo dynamics effect (preset) Program Change 0 to 1
Stereo dynamics effect (user) Program Change 0 to
99 (maximum)
Single effect (preset) Program Change 0 to 6
Single effect (user) Program Change 0 to 99 (maximum)
Multi effect (preset) Program Change 0 to 31
Multi effect (user) Program Change 0 to 99 (maximum)
ª
Scene memory Program Change messages
These are transmitted on channel 16. The Program Change
message may be from 0 to 99.