Tascam 2488neo - Manual (Page 107)

15 − Appendix
TASCAM 2488neo
107
Stereo dynamics processor
The dynamics processor inserted at the stereo master bus
can be either a compressor or an expander. Use MIDI chan-
nel 9 to control this processor.
Effect NRPN Parameter Values
Compressor (CMP)
00 00 Threshold 0 – 32 = –32 – 0 dB
00 01 Ratio
0 – 14 = 1.0:1, 1.1:1, 1.3:1, 1.5:1, 1.7:1, 2.0:1, 2.5:1, 3.0:1, 3.5:1, 4.0:1,
5.0:1, 6.0:1, 8.0:1, 16:1, ∞:1,
00 02 Attack 1 – 100 = 2 – 200 (msec)
00 03 Release 1 – 100 = 10 – 1000 (msec)
00 04 Post Gain 0 – 32 = 0 – 32 (dB)
00 05 Switch 0, 1 = Off, On
Expander (EXP)
00 00 Threshold 0 – 32 = -32 – 0 dB
00 01 Ratio
0 – 14 = 1:1.0, 1:1.1, 1:1.3, 1:1.5, 1:1.7, 1:2.0, 1:2.5, 1:3.0, 1:3.5, 1:4.0,
1:5.0, 1:6.0, 1:8.0, 1:16, 1:32,
00 02 Attack 1 – 100 = 2 – 200 (msec)
00 03 Release 1 – 100 = 10 – 1000 (msec)
00 04 (reserved)
00 05 Switch 0, 1 = Off, On
Use MIDI channel 10 to control this processor. The single
processor can use any one of a number of effect types:
reverb, delay, chorus, pitch shifter,flanger, phaser and
gated reverb.
Single effect
Effect NRPN Parameter Values
Reverb (REV)
00 00 Room Type 0 – 3 = Hall, Room, Live, Studio
00 01 Pre Delay 0 – 250 = 0 – 250 (msec)
00 02 Rev Time 1 – 100 = 0.1 – 10.0 (sec)
00 08 Diffusion 0 – 100 = 0 – 100
00 04 Level 0 – 127 = 0 – 127
Delay (DLY)
00 00 Type 0 – 2 = Normal, Pan, Multi
00 01 Pre Delay 0 – 1000 = 0 – 1000 (msec)
00 02 FB Delay 0 – 1000 = 0 – 1000 (msec)
00 03 Feedback 0 – 100 = 0 – 100
00 04 Level 0 – 127 = 0 – 127
Chorus (CHO)
00 00 Rate 1 – 100 = 0.1 – 10.0 (Hz)
00 01 Depth 0 – 100 = 0 – 100
00 02 FB Delay 0 – 100 = 0 – 100
00 03 Feedback 0 – 100 = 0 – 100
00 04 Level 0 – 127 = 0 – 127