Tascam 2488neo - Manual (Page 119)

No. Message Meaning Action
18
No tracks have
been armed. Arm
at least one
track.
Press [EXIT]. Before an auto-punch operation, you must have
at least one armed track. Press NO/EXIT and press the REC key of at
least one track on which you will be recording
(once a track has been armed in auto-punch,
the track arming status cannot be changed).
19
Non-linear
audio detected.
Check your
system set-up
Press [EXIT]. Digital audio input mode has been selected,
but the 2488neo has detected the wrong data
format for the incoming digital audio to be used. Press NO/EXIT and check the digital audio
source. The 2488neo expects a signal in S/
PDIF (IEC60958 Consumer use) format at
44.1 kHz. It cannot accept compressed audio
formats, etc.
20
Not enough free
disk space. Use
DELETE UNUSED
to make space.
Press [EXIT]. Copying a song has failed because there is not
enough space on the selected or target partition. Press NO/EXIT and use one of the SONG
menu operations such as DELETE UNUSED or
ERASE to free up some space on the partition
where there is not enough space (these opera-
tions cannot be undone).
21
Not enough free
memory. Use
DELETE UNUSED
to free memory.
Press [EXIT]. Sometimes after repeated operations, the inter-
nal memory of the 2488neo becomes used, and
recording, etc. is not possible. Press NO/EXIT. Use the DELETE UNUSED
menu item from the SONG menu. As well as
deleting the unused song data, this action
will also free up memory, so recording can
continue. Remember that this operation
cannot be undone.
22
Not enough room on
CD for burn. Use
another CD [YES]
or cancel [NO]. Too much data has been selected to fit onto the
CD that is currently loaded. Press YES/ENTER to change the CD for
another one, or NO/EXIT to cancel the current
operation. Use a higher-capacity disc when
burning a master track or exporting data, or
one of the same capacity as the current disc
when backing up.
23
Not enough room
on hard disk for
this operation.
Press [EXIT]. No enough space on the hard disk to create the
image file necessary to create a CD. Press NO/EXIT and create space by deleting
songs, etc., (SONG->ERASE) backing them up
if necessary (this operation cannot be undone).
You can free up space on a partition other than
the current partition (use the DISK->SELECT
function) in order to create space for the image.
24
Protected song.
Unprotect with
SONG PROTECT.
Press [EXIT]. Recording, track editing, recording, titling, etc.
cannot be carried out when the current song
has been protected. Press NO/EXIT, and use the PROTECT menu
item from the SONG menu to remove the
protection from the song before proceeding.
25
Repeat mode is
selected.
Cannot do this
operation now.
Press [EXIT]. Because repeat mode is selected, the following
functions cannot take place: locate operation,
track editing, undo/redo, auto punch, quick
routing, all menu operations, and shutdown. Press NO/EXIT and cancel the repeat mode
(REPEAT key) before proceeding with the
operation that produced this message.
26
SSA mode is
selected.
Cannot do this
operation now.
Press [EXIT]. Because SSA mode is selected, the following
functions cannot take place: MTC slave opera-
tions, jog and trim functions, recording (includ-
ing auto-punch) and digital input. Press NO/EXIT and cancel the SSA mode
(PITCH/SSA key) before proceeding with the
operation that produced this message.
15 − Appendix
TASCAM 2488neo
119