Toshiba TLPX10E - Manual (Page 80)

80
CONTENTS
Document
imaging camera
With the document camera operating, fully
cover the camera lens with a piece of black
paper or cloth. 1
Correcting illuminated defects
Note
Do not press ARM LIGHT and EXIT buttons simultaneously if the camera lens is not
covered. Doing so will not only erase the white spot correction data already set but also
result in parts that are displayed normally being corrected. Also be careful if the camera
input mode is not selected.
ARM LIGHT
EXIT
TEMP LAMP ON
BUSY FAN
KEYSTONE SET
AUTO AUTO
EXIT ENTER
MENU INPUT
VOL/ADJ.
ON/STANDBY
TEM P LA MP ON BUSY FAN
ON/S TAND BY
KEYS TONE SET AUTO AUTO
EXIT ENTE R MEN U INPU T
VOL/A DJ.
STORE CAMER A ARM LIG HT
LOCK W.BALA NCE GAIN
FO CU S
2
LOCK
STORE IMAGE
CAMERA
ARM LIGHT W.BALANCE
CAMERA GAIN
FOCUS
Press ARM LIGHT on the camera control panel
and EXIT on the projector’s control panel
simultaneously.
You can not use the remote control buttons.
2
Camera control panel
Control panel
(Main unit side)
Press both sides
Camera lens
For the CCD image sensor used in the camera unit, in rare cases some of the pixels may
be disturbed due to the influence of cosmic rays, etc. This disturbance may cause white
spots to appear on the picture.
If white spots appear on the document camera image, use the procedure described below
to correct it.