Toshiba TLPX10E - Manual (Page 50)

50
CONTENTS
Adjustments &
Settings
3-a
3-a
MENU
ON/STANDBY INPUT
L-CLICK R-CLICK
ENTER
KEYSTONE AUTO SET
EXIT
PIP FREEZE
MUTE CALL RESIZE
VOLUME/ADJUST
TEMP LAMP ON
BUSY FAN
KEYSTONE SET
AUTO AUTO
EXIT ENTER
MENU INPUT
VOL/ADJ.
TEMP LAMP ON BUSY FAN
ON/ST ANDBY
KEYST ONE SET AUTO AUTO
EXIT ENTER MENU INPUT
VOL/ADJ .
ON/STANDBY
LASER
3-a Press VOL/ADJ (+/-) to adjust and set.
Adjustments
Buttons Items (-) (+)
Contrast Lower Higher
Brightness Darker Brighter
Color Thinner Deeper
Phase Adjust flickers Adjust flickers
Keystone Reduce the lower width Reduce the upper width
Settings
Picture mode (Analog RGB input, digital RGB input)
Bright: Set the picture with its brightness priority.
True color: Set the picture with its quality (color) priority.
Lamp power
Hi: Set the lamp mode with brightness priority.
Low: Restrict the lamp output to reduce the cooling sound.
Auto. demo (Memory card input)
On: When a memory card is detected while the memory card
input mode is selected, a slide show using the image data in
the root directory starts automatically.
Shutter (Document imaging camera input)
Set to the frequency (50/60 Hz) of the power supply in your area.
Note
The cooling sound changes according to the temperature inside the projector. When the
lamp power setting is changed, the brightness changes immediately, but the cooling sound
level does not change immediately.
QUICK MENU adjustments and settings (continued)
Continued
Remote control
Control panel
(Main unit side)
When selecting “Contrast”, “Brightness”, “Color”, “Phase”, “Keystone”, “Picture mode”,
“Lamp power”, “Auto. demo” or “Shutter” in step 2.