Toshiba TLPX10E - Manual (Page 22)

22
Installation and
connection
CONTENTS
Notes
• The projector cannot be connected to a computer without an analog RGB connector. For details, refer to the computer manual.
• When connecting to a Macintosh computer, use the supplied Mac adapter (Multiple Scan 21 compatible). For some models the adapter is not required.
• You may not be able to connect some computers to the projector. For details, consult the dealer.
• Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal levels, timing,
resolutions, etc.
Connecting a computer
You can project the picture from the computer.
Check that the power for the projector and computer is off before connecting the cables.
USB
MONIT
OR OUT
COMPUTER IN 1 ( Y/P B/P R )
COMPUTER IN 2
CONTR
OL
S-VIDEO
VIDEO VIDEO IN
R - A UDIO - L
AUDIO IN AUDIO OUT
USB MONITOR OUT COMPUTER IN 1
( Y/P B /P R )
COMPUTER IN 2 CONTROL
S-VIDEO VIDEO
VIDEO IN
R - AUDIO - L
AUDIO
IN
AUDIO
OUT
COMPUTER IN 1 Connector
For use as both analog RGB1 input and Y/P
B /P R input. At shipping from
factory, it is set for use as analog RGB1 input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB1/analog
RGB2/digital RGB) and Y/P
B /P R input.
ø3.5mm Stereo mini-jack
To audio output port
RGB cable (supplied)
To AUDIO IN jack
Computer
To COMPUTER IN 1 connector
Be sure to connect in the proper
direction.
To monitor port ( )
Audio cable (supplied)
Connecting a Mac adapter for
Macintosh computers (supplied)