Toshiba TLPX10E - Manual (Page 61)

61
CONTENTS
Adjustments &
Settings
MENU
ON/STANDBY INPUT
L-CLICK R-CLICK
ENTER
KEYSTONE AUTO SET
EXIT
PIP FREEZE
MUTE CALL RESIZE
VOLUME/ADJUST
TEMP LAMP ON
BUSY FAN
KEYSTONE SET
AUTO AUTO
EXIT ENTER
MENU INPUT
VOL/ADJ.
5
5
4
4
TEMP LAMP ON BUSY FAN
ON/ST ANDBY
KEYST ONE SET AUTO AUTO
EXIT ENTER MENU INPUT
VOL/ADJ .
ON/STANDBY
LASER
After the settings are finished, press EXIT.
The menu screen disappears.
EXIT
EXIT 5
Press VOL/ADJ (+/-) to adjust and set. 4
Notes
• If the power is turned off by pressing the ON/STANDBY button, the adjustments or settings
made are automatically stored in the memory. If the power cord is unplugged or if a power
failure occurs while the projector is on, the adjustments or settings are not stored in the
memory.
• The “Audio” settings are applied to all the input sources. (It is impossible to change the
settings for each input source.)
• The settings do no affect on the audio output signals from the AUDIO OUT jack.
• If either the memory card input or the document imaging camera input mode (for models with
document imaging camera) is selected, the sound is not developed.
Speaker output
When set to “Off”, no sound is produced from the speakers.
Channel select
L+R: The sound of the left and right channels is mixed and
developed from the speakers.
L: To develop only left input audio signal from the speakers.
R: To develop only right input audio signal from the speakers.
Loudness
When set to “On”, the loudness effect is added to the speaker
sound.
FULL MENU settings – Audio (continued)
Remote control
Control panel
(Main unit side)