Toshiba TLPX10E - Manual (Page 31)

31
Operations
CONTENTS
Turning the power off
Press ON/STANDBY after using the projector.
An instruction message appears.
Press ON/STANDBY again.
Cooling starts. Once cooling is completed, the LAMP and FAN
indicators turn off and the standby mode is set. (The ON
indicator turns in orange.)
To protect the light source lamp, the LAMP indicator blinks as long as
a minimum of cooling is necessary. The power cannot be turned back
on during this time. Unplugging the power cord at this time will shorten
the lamp’s duration life.
The cooling fan continues to run for a while to expel the heat remaining
inside. If you are in a hurry, however, you may unplug the power cord
at this time.
The standby mode is set.
1
2
MENU
ON/STANDBY INPUT
L-CLICK R-CLICK
ENTER
KEYSTONE AUTO SET
EXIT
PIP FREEZE
MUTE CALL RESIZE
VOLUME/ADJUST
1,2
1,2
2
TEMP LAMP ON
BUSY FAN
KEYSTONE SET
AUTO AUTO
EXIT ENTER
MENU INPUT
VOL/ADJ.
TEMP LAMP ON BUSY FAN ON/ST ANDBY
KEYST ONE SET AUTO AUTO
EXIT ENTER MENU INPUT
VOL/ADJ .
ON/STANDBY
LASER
ON
FAN
ON LAMP LAMP
FAN
ON LAMP
FAN
A B C
(Green)
Flashing
(Orange)
(Green)
(Off) (Orange)
(Green)
(Off) (Orange)
(Off)
B
C
Indicators
A
Remote control
Control panel
(Main unit side)
Notes
• The projector consumes about 20W of power in the standby mode. We recommend you to
unplug the power cord when not using the projector for long periods of time.
• Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the
power by unplugging the power cord while the projector is operating or the light source lamp is
being cooled will shorten the lamp’s duration life.