Omron CQM1H-CLK21 - Manual (Page 340)

317
Error Log Section 9-3
0109
Hex Transmission failed; destination
busy Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Increase number of
retries or reconfig-
ure system to distrib-
ute load. No All
010A
Hex Transmission failed; communica-
tions controller error Conduct an echo-
back test and if the
effects of noise are
considerable, recon-
sider the operating
environment. Restart
the Controller Link
Unit. If the error
occurs again,
replace the Unit. Yes All
010B
Hex Transmission failed; PLC error Refer to the PLC
operating manual. If
the error occurs
again, replace the
PLC. No All
010C
Hex Transmission failed; unit number
incorrect Check unit number
settings to be sure
they are within range
and unique. No CV, CS/CJ
010D
Hex Transmission failed; destination
address incorrect Check routing tables. No All
010E
Hex Transmission failed; routing
tables not registered Check routing tables No All
010F
Hex Transmission failed; routing table
error Check routing tables. No All
0110
Hex Transmission failed; too many
relay points Check routing tables
and system configu-
ration. Use a CS/CJ-
series CPU Unit with
unit version 2.0 or
later and CX-Pro-
grammer Ver. 4.0 or
higher to send com-
mands across three
or more network lev-
els. No All
0111
Hex Transmission failed; command
packet too long Be sure to use the
FINS command
format. No All
0112
Hex Transmission failed; header
error. Be sure to use the
correct FINS
command format. No All
0113
Hex Transmission failed; I/O setting
error Check I/O table
accuracy. No CV, CS/CJ
0114
Hex Transmission failed; CPU bus
error Check Unit and cable
connections and
clear error. No CV, CS/CJ
0115
Hex Transmission failed; redundant I/
O allocations Check unit numbers
for redundancy within
the same PLC. No CV, CS/CJ
0116
Hex Transmission failed; CPU Bus
Unit error Check Unit and cable
connections and
clear error. No CV, CS/CJ
Error
code
Contents Detail code Correction Written to
EEPROM
Applicable
PLC
1st byte 2nd byte