Omron CQM1H-CLK21 - Manual (Page 259)

236
Remote Programming and Monitoring Section 7-2
7-2 Remote Programming and Monitoring
A remote PLC can be programmed and monitored across a network from a
Programming Device connected to a PLC.
7-2-1 Local Networks
SYSMAC Support Software and CV Support Software
A Programming Device connected to a C200HX/HG/HE, CVM1, or CV-series
CPU Unit can program and monitor a C200HX/HG/HE, CVM1, or CV-series
PLC on the same network. Programming and monitoring are possible, how-
ever, only for the same type of CPU Unit as the one to which the Programming
Device is connected. For example, if the Programming Device is connected to
a CVM1 or CV-series PLC, you can only program and monitor CVM1 or CV-
series PLCs on the network.
SYSMAC Support
Software Programming Device
Programming
and monitoring
SYSMAC Support
Software (CVM1 only)
or
CV Support Software
Note A factory automation node computer cannot remotely program or
monitor. The node can only monitor Controller Link Network status.
Controller Link Network
C200HX/HG/HE
Controller Link Network
Programming Device
Programming
and monitoring
CVM1, or CV-series PLC CVM1, or CV-series PLC
Controller Link
Support Software
C200HX/HG/HE