Roland VS-880EX - Manual (Page 98)

Amplitude
This specifies the volume level ratio (50, 60, 70, 80, 90,
100%) that will result from the conversion. Normally,
the default value of 60% is recommended. If the vol-
ume level after conversion is too low, use the Undo
function to return to the original data, increase the
amplitude settings, and try the operation again.
However, excessively high settings can introduce
noise in the data.
20. Press PARAMETER [ ].
“TRK TimeComp/Exp. OK ?” appears in the display.
21. Press [YES].
This executes Time Compression/Expansion. If you
wish to cancel, press [NO].
* Be aware that, depending on conditions, it may take some
time for compression or expansion to be completed. This is
not a malfunction. Progress of the operation is shown in
the display:
do not turn off the power until the
compression or expansion the track is complet-
ed
. You can cancel compression or expansion by pressing
[NO].
22. When the compression or expansion is completed
correctly, “Complete” appears in the display, and
return to Play condition.
Chapter 6 Editing a Recorded Performance (Track Editing)
98