Roland VS-880EX - Manual (Page 69)

Settings for Each Channel
1. Press [CH EDIT (SELECT)] for the channel to
which you want to apply the effect.
The CH EDIT indicator lights.
2. Hold down [SHIFT] and press the channel 7
[EFFECT-1 (CH EDIT)].
The upper line of the display will indicate “EFFECT
1,” and you can make settings for effect 1.
3. Select how the effect will be connected. Rotate the
TIME/VALUE dial.
EFFECT 1 (Effect 1 Send Select Switch)
This selects the how the signal is sent to the EFFECT 1
bus (send).
Off: The signal is not sent.
PreFade: The sound before passing through the
channel fader is sent.
PstFade: The sound after passing through the
channel fader is sent.
4. Press PARAMETER [ ].
“EFFECT1 Send=” appears in the display.
5. Rotate the TIME/VALUE dial.
EFFECT1 Send (Effect 1 Send Level)
This adjusts the volume level of the signal (0–127) sent
to the EFFECT 1 bus. Set the initial value to “100.”
6. Press PARAMETER [ ].
“EFFECT1 Pan=” appears in the display.
7. Rotate the TIME/VALUE dial.
FFFECT1 Pan (Effect 1 Send Pan)
This adjusts the stereo placement of the signal
(L63–0–R63) sent to the EFFECT 1 bus.
8. Press [PLAY (DISPLAY)].
Return to Play condition.
9. You can use the same method to make settings for
each channel for FX2 as well. In this case, hold
down [SHIFT] and press channel 8 [EFFECT-2
(CH EDIT)] in step 2.
Master Block Settings 1
(Send Level Adjustment)
You can adjust the balance of the total effect send level
for each effect with the effect send level and send pan
settings that are assigned to each individual channel
left as they are.
* If FX1 has been inserted into another channel, or if it has
been inserted into the MASTER OUT jacks, these dis-
plays will not appear (settings cannot be made).
1. Hold down [SHIFT] and press [EDIT (FADER)].
2. Press PARAMETER [ ] [ ] until “MST
FX1 SND Lev=” appears in the display.
3. Rotate the TIME/VALUE dial.
MST FX1 SND Lev (Master Effect 1 Send Level)
This adjusts the total volume level of the signal (0–127)
sent to the effect. Set the initial value to “100.”
4. Press PARAMETER [ ].
“MST FX1 SND Bal=” appears in the display.
5. Rotate the TIME/VALUE dial.
MST FX1 SND Bal
(Master Effect 1 Send Balance)
This adjusts the balance (L63–0–R63) of the total signal
sent to the effect. Set the initial value to “0” (center).
6. Press [PLAY (DISPLAY)].
Return to Play condition.
7. You can adjust the send level in the same way for
FX2 as well. In this case, access the “MST FX2
SND Lev=” display in step 2.
Master Block Settings 2
(Return Level Adjustment)
Use the channel faders and pan knobs on the top panel
to adjust the effect on volume (return level).
1. Press [FADER (EDIT)] several times until the
FADER indicator lights red.
2. Press the channel 7 [EFFECT-1 (CH EDIT)].
The CH EDIT indicator lights.
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
Chapter 4 Using the Internal Effects
69
Chapter 4