Roland VS-880EX - Manual (Page 135)

2. Insert the tape which contains the song data into
the DAT recorder. If the song data is backed up
on two or more tapes, insert the first tape.
3. Prepare the tape for playback from the beginning
of the song data.
4. Press [SONG] several times until “SNG DAT
Recover?” appears in the display.
5. Press [YES].
“STORE Current?” (Store the current song?) appears
in the display.
6. If you wish to save the current song, press [YES];
if not, then press [NO]. If you have selected a
demo song, then press [NO] .
7. “D.IN Sel =” appears in the display. Rotate the
TIME/VALUE dial.
D.IN Sel (Digital In Select)
Select either “DIGIN1” (coaxial) or “DIGIN2” (optical)
if you are going to recover data using the VS-880EX’s
DIGITAL IN connector.
8. Press PARAMETER [ ] thrice.
“Verify Ready?” appears in the display.
9. Press [YES].
“Please Play DAT” appears in the display.
10. Put the DAT recorder in play mode.
Verify the tape. If you have backed up the data to mul-
tiple tapes, then the operation is suspended when the
end of each tape is reached. Insert the number tape
indicated in the display, press [YES], and start the
DAT recorder playing again.
11. When loading is finished, “Please Stop DAT”
appears in the display. Stop the DAT recorder,
then press [YES].
12. If there is no problem with the condition of the
recorded song data, “Complete” appears in the
display. If “Verify Error, Retry?” appears when
the song data is loaded, then that song data can-
not be loaded correctly. If you wish to check a
tape again, insert the number tape indicated in the
display, press [YES], and start the DAT recorder
playing again. Press [NO] if you want to finish the
procedure without checking the tape again.
* To cancel this operation, press [CANCEL (NO)].
DAT Recorder
Coaxial
Digital Out
Chapter 10 Use with a DAT Recorder (DAT Backup)
135
Chapter 10