Roland VS-880EX - Manual (Page 106)

17. When copying over multiple Zip disks, “Insert
Disk #” (# indicates the number in the order of
insertion) appears in the display. Insert each of
the disks once more in the proper order and press
[YES].
18. When the Archives Store procedure is finished,
return to Play condition.
Loading Data From Disks (Extract)
1. Select the load (restore) destination drive (internal
hard disk) as the current drive.
2. Insert a disk that was copied by Archives Store
into the Zip drive.
3. Press [SONG] several times until “SNG Song
Copy ?” appears in the display.
4. Press [YES].
“SNG CpyMode=” appears in the display.
5. Rotate the TIME/VALUE dial. Here, select
“Archives.”
CpyMode
Select how the song will be copied.
Playable: Playable type.
Archives: Archives type.
6. Press PARAMETER [ ].
“SNG ArcTarget=” appears in the display.
7. Rotate the TIME/VALUE dial. If you wish to
copy the current song, select “1 Song.” To copy all
songs from the current drive, select “All.”
8. Press PARAMETER [ ].
“SNG Arc.Drive=” appears in the display.
9. Rotate the TIME/VALUE dial. select the disk
drive from which the data will be loaded. For this
operation, you will be able to select only remov-
able disk drives which are connected to the SCSI
connector. It is not possible to select the current
drive (the internal hard disk) as the copy destina-
tion drive. For example if you wish to copy from a
Zip disk, select “SC5:0.”
10. Press PARAMETER [ ].
“SNG Arc.Func=” appears in the display.
11. Rotate the TIME/VALUE dial. Here, select
“Extract.”
Arc.Func (Archives Function)
Select the Archive Type copy method.
Store: Saving to Zip Disks.
Extract: Loading from Zip Disks.
12. Press [YES].
A message asking if you want to continue appears in
the display.
13. Press [YES].
In step 7, select “1 Song.” If two or more songs were
saved to the Zip disk, the names of the saved songs
will also be displayed. Use the TIME/VALUE dial to
select the name of the song you wish to copy.
14. Press [YES].
“STORE Current?” (Store the current song?) appears
in the display.
15. If you wish to save the current song, press [YES];
if not, then press [NO]. If you have selected a
demo song, then press [NO] .
16. If you have selected “All” in step 3, the display
will ask “Init. IDE:0 OK?” This message is asking
you to confirm that you wish to initialize the load-
ing destination drive (the internal hard disk). If
you wish to initialize the drive and then load,
press [YES]. If you decide not to initialize, press
[NO].
* If at this point you press [YES], all songs saved on the
internal hard disk will be lost. Normally you should press
[NO]. If the loading destination hard disk does not have
sufficient space, you should first make a backup copy of
the internal hard disk, and then press [YES].
17. Execute the load. When copying over multiple
disks, “Insert Disk #” (# indicates the number in
the order of insertion) appears in the display.
Insert the next disk and press [YES].
18. When the Archive Extract procedure is finished,
return to Play condition.
About power-save mode
If approximately thirty minutes pass without data
being written to or read from a disk, a Zip drive will
automatically stop rotation of the disk. This is referred
to as
Auto Power Save mode (Sleep mode) . This
function limits the power consumption and extends
the life of the disk. When you perform a read or write
operation on the disk, it will return to its normal state.
This will take two or three seconds.
Chapter 7 Use with a Zip Drive
106