Deleting a stored time location, Using markers, Marking a time location – Roland VS-880EX User Manual
Page 38: Moving the location of markers, Chapter 2 basic operation 38
Deleting a Stored Time Location
1. While holding down [CLEAR], press the LOC
button ([1/5]–[4/8]) for locate point that you wish
to delete. For example, if you wish to delete the
LOCATOR 1’s located point, then press [CLEAR]
and [1/5] simultaneously. If you wish to delete
the time that was registered in Locator 5, hold
down [SHIFT] and press [CLEAR] and [1/5].
Using Markers
Along with the playback locate points, you can set up
to 1000 Markers in sequence. The Markers are also a
useful and convenient way to define sections of a song
to be repeated in Loop Recording or for marking
points in Punch-In Recording.
* An interval of at least 0.1 seconds must left between
markers. It will not be possible to add a new markers if a
markers already exists at a location less than 0.1 seconds
away.
Marking a Time Location
Press [TAP], and a marker will be added to the current
location. This can be done during recording or play-
back of the song as well as when the song is stopped.
Moving the Location of Markers
To move to the Marker immediately preceding the
current playback time, press [PREVIOUS]. You move
ahead one marker at a time in the order they are
placed each time the button is pressed. To move to the
Marker immediately following the current playback
time, press [NEXT].
0
1
2
3
4
5
6
TAP
TAP
TAP
TAP
TAP
TAP
TAP
00h00m00s00
Time
0
1
2
Time
PREVIOUS
NEXT
Displaying Markers
The Marker number at any playback location is
indicated in the display. If there is no Marker
number in the current location, then the closest
preceding Marker number is displayed. If there
are no markers in the song, “—” is indicated. If
“***” is shown in the display, it indicates that
although there are markers placed in the song, the
current location is before the first marker.
Chapter 2 Basic Operation
38
About Marker Numbers
Each marker is assigned a number 000-999, in the
order of its time location. This means that if you
add a new marker at a location earlier than an
existing marker, the numbers of the subsequent
markers will be incremented.
0
1
2
3
TAP
Time
Before setting a Marker
0
1
3
4
2
Time
After setting a Marker