Ricoh JP8000 - Manual (Page 206)

Troubleshooting
186
5
When Prints are not Delivered in a Neat
Stack
When Printing on Small Size
Paper
A
Adjust the end plate angle by
turning the screw clockwise or
counterclockwise.
When the Machine Cannot
Detect the Paper Size
If the paper size is not detected cor-
rectly when printing, prints might not
be delivered in a neat stack. To solve
this, do one of the following:
A
Raise the lock lever for the paper
feed side plates to release the
lock.
B
Re-adjust the paper feed side
plates so that there is no space be-
tween the paper feed side plates
and paper, and then lock the side
plates in position.
Note
❒ Make sure that the paper size
and direction in the panel dis-
play match the actual paper size
and direction place on the paper
feed tray.
❒ If the paper on the paper feed
tray has a solid image on its
back side, the machine may not
be able to detect the size correct-
ly. Place a sheet of paper of the
same size without an image on
the back at the bottom of the pa-
per stack.
ZDCH150E
ZDCY111E
ZDCY030E