Ricoh AP1400/AP2000 - Manual (Page 105)

Type 1 Printer: Loading Paper and Other Media
85
9
sides of the flaps on the right as
shown in the illustration.
Important
❒ Make sure that the envelope
flaps are securely folded down,
and that there is no air inside
the envelopes.
Note
❒ Make sure that the top of the
stack is not higher than the limit
mark on the side guides.
❒ Do not press down on the stack
of envelopes with too much
force.
D
Slide the side guides against the
edge of the envelope stack.
Note
❒ Make sure that the edges of en-
velopes fit under the side
guides.
E
Specify the envelope size and
feed direction using the operation
panel as follows.
A Press {
Menu
}
The following message appears.
Main Menu: j
Job Control l
B Press {
Enter
}.
The following message appears.
Job Control: j
1.Paper Input l
C Press {
Enter
}.
D Press {U}{T} until the follow-
ing message appears.
Paper Input: j
3.Paper Size l
E Press {
Enter
}.
The following message appears.
Paper Size: j
1.Bypass Tray l
F Press {
Enter
}.
G Using {U}{T}, select the enve-
lope type you want to use.
Reference
For informations on types of
envelopes you can select, see
P.65 “Paper and Other Media
Supported by Your Printer”.
H Press {
Enter
}.
I After the panel display chang-
es, press {
On Line
}.
The panel display returns to the
ready condition as follows:
Ready
F
Start the print operation with
your computer.
Type 1 printer: loading envelopes into
the envelope feeder
Note
❒ Please refer to the inside of the
front cover of this manual to con-
TS3Y311E