Roland R-1 - Manual (Page 35)

English
Deutsch
Français
Italiano
Español
35
Basic recording methods
This section explain how to record audio from an external device via the line input jack.
* The R-1 does not have a digital input jack.
As an example, here’s how to record from a CD player into the R-1.
fig.cd
The microphone input is disabled if you connect a device or cable to the line
input jack. This means that you cannot record the microphone input and line
input mixed together. If something is connected to both the line input jack and
the mic input jack, only the sound entering the line input jack will be recorded.
1
Make sure that the R-1’s power is turned off. Set the input volume to the
minimum position.
2
Turn on the R-1’s power as described in “Connecting the AC adaptor and
turning on the power” (p. 19).
3
Specify the type of file you want to record, as described in “Types of files that the
R-1 can handle” (p. 28). You can use Setup mode 07 Record Mode (p. 54) to
specify the desired setting or to check the current setting.
4
Use an audio cable to connect the output jacks of your CD player to the R-1’s line
input jack .
5
On your CD player, play back the song that you want to record and adjust the
input level as described below. ->
“Adjusting the input level” (p. 36)
Recording from a cassette tape or CD
CD/MD player, cassette deck, etc.
LINE IN
LINE OUT
R-1_egfis1.book 35 ページ ２００５年１１月１１日 金曜日 午後５時１３分