Roland R-1 - Manual (Page 19)

English
Deutsch
Français
Italiano
Español
19
Getting ready to use the R-1
941
* Once the connections have been completed (p. 18), turn on power to your various devices in
the order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power
up is required before the unit will operate normally.
* If batteries are installed and the AC adaptor is also connected, the power will be supplied
from the AC adaptor.
1
Turn off the R-1’s power switch .
fig.off
2
Connect the DC plug of the AC adaptor to the DC IN jack on the rear panel of the
R-1.
* Use only the AC adaptor supplied with the R-1.
3
Plug the AC adaptor into an AC outlet.
4
Turn on the R-1’s power switch .
fig.on-off
* If batteries are installed and the AC adaptor is also connected, the power will be supplied
from the AC adaptor.
Connecting the AC adaptor and turning on the power
OFF
ON
R-1_egfis1.book 19 ページ ２００５年１１月１１日 金曜日 午後５時１３分