Roland KR111 - Manual (Page 18)

First steps
16
r
KR111 Digital Intelligent Piano
(3) If necessary, press another [Tone] button to select
another song.
If you like, you can press [Song] to launch playback of
the general demo song (see above).
(4) Press [Start÷Stop] to stop Tone demo song playback.
Playing back a Style demo song
(1) Select demo mode (see step (1) above).
(2) Press a [Music¥Style] button to select the demo song
of the corresponding family.
Playback of the Style demo song starts automatically.
The display’s message line now looks as follows:
You can now press [Start÷Stop] to stop playback of the
currently selected Style demo song. If you press this
button again, the next Style demo song will be played
back.
(3) If necessary, press another [Style] button to select
another song.
If you like, you can press [Song] to launch playback of
the general demo song (see above).
(4) Press [Start÷Stop] to stop Style demo song playback.
Leaving demo mode
Press the [Transpose] and [Reverb] buttons simulta-
neously to leave demo mode.
Connecting external amplifiers and
other devices
If the KR111’s amplification system doesn’t deliver
enough power for your application, you can take
advantage of its Output jacks.
Sending audio to external equipment
Before connecting the KR111 to another device, turn
off the power to both devices.
If you wish to amplify the KR111 through an external
system, or record your music using a tape recorder,
connect the KR111’s Output jacks to the AUX IN, LINE
IN or CH IN jacks of the external (keyboard) amplifier,
mixer or tape deck.
Note: If you are connecting the KR111 to a device with a
monaural input, use the L/Mono jack.
Note: For cassette decks or HiFi amplifiers, you need audio
leads with mono jacks at one end and (usually) RCA/cinch
jacks at the other.
After connecting the KR111 to the amplifier, etc., be
sure to switch on the KR111 and the external
device(s) in the following order:
• First turn on the power to the KR111.
• Then turn on the power to the mixing console, amp,
etc. (in that order).
Receiving audio signals from external sources
You can connect the audio outputs of an external MIDI
instrument, CD or cassette player, etc., to the INPUT
jacks. That has the advantage that such signals can be
amplified by the KR111 and are therefore also present
in the headphones (if connected).
To connect an external signal source, follow the
instructions above but be sure to connect the LINE OUT,
etc., jacks of the external source to the KR111’s Input
jacks.
=
DemStyle
101
Stereo
R L (Mono)
Input
Stereo
R L (Mono)
Output
To the AUX IN/LINE IN jacks of the external
amplifier/mixer, etc.
Stereo
R L (Mono)
Input
Stereo
R L (Mono)
Output
From the LINE OUT, etc., jacks of the external
instrument, CD player, etc.