Nortel Networks COOLPIX P7000 - Manual (Page 47)

33
Using the Flash
Bas
ic Ph
otography an
d Pl
ayba
ck
: A
(Auto)
M
o
de
Setting the Flash Mode
1
Press the
K (flash pop-up) button.
• Built-in flash is raised.
• When the built-in flash is lowered, the flash mode is fixed to W (Off ).
2
Press
m (flash mode) on the rotary multi
selector.
• The flash mode menu is displayed.
3
Use the rotary multi selector to choose the
desired mode and press the
k button.
• When the manual flash is chosen, choose the flash
output with J or K before pressing the k button.
• The mode selected for the flash is displayed.
• When U (Auto) is applied, D is only displayed for
a few seconds even if monitor indicators ( A14) are
turned on.
• If the k button is not pressed within a few seconds, the
selection is set and the setting menu disappears.
B
Lowering the Built-in Flash
When not using the built-in flash, gently push to lower the flash until
it clicks shut.
Auto
1/250 1/250 1/250 32 32 32 F5.6 F5.6 F5.6