Nortel Networks Modular ICS 4.0 - Manual (Page 17)

Getting started with Norstar / 5
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
The M7324 is different from the M7310 in two ways: it does not
have dual memory buttons (item 5) or a shift button (item 6).
Using the buttons under the display
The three display buttons are used both for telephone features
and programming, but what each button does depends on what
the display shows. Some display instructions that you may see
when making changes on the system are
OK , CHANGE or COPY . In
this guide, display button instructions are underlined.
Display buttons
Dial pad
Used for dialing numbers when you are making
calls. It’s also used for entering numbers and
letters when you’re programming.
Display
Shows instructions for everyday calling as well as
for programming.
Display buttons
Have a variety of uses. The current use is shown
on the display above each button.
Memory buttons
Dial a number or feature code stored on the
button.
Dual memory buttons
Can store two numbers or feature codes (used
with the shift button).
Shift button
Press the shift button before a dual memory
button to activate the second number or feature
code stored on a dual memory button.
Feature button
Allows you to enter a feature code while using or
programming the telephone.
Hold button
Puts an active call on hold.
Release button
Hangs up an active call or ends programming.
1
2
3
4
5
6
7
8
9
display button
p0881591.book Page 5 Wednesday, August 19, 1998 6:43 PM