Nortel Networks Modular ICS 4.0 - Manual (Page 111)

Communicating in the office / 99
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
You can send up to four messages to different telephones,
including your voice message center. If your telephone is a
direct-dial telephone or a central answering position (CAP),
you can send up to 30 messages.
Only the designated direct-dial telephone for an analog
telephone connected to an Analog Station Module (ASM) can
send messages to analog telephones by pressing
ƒ⁄. Depending on the programming setup, the
analog telephone provides either a Stuttered Dial Tone or a
Message Waiting Lamp to inform the user of messages
pending.
If your reply to a message is forwarded or is answered at
another telephone using the Call Pickup feature, the message
remains on your telephone until you cancel it or successfully
contact the telephone that sent the message.
For analog telephones connected to an ASM, the message
waiting indicator remains on until the user invokes
˚£flfi. If the analog telephone has the Message
Reply Enhancement feature set to Yes, the message waiting
indicator is turned off automatically after the reply call is
answered no matter from where the call is answered.
For more information on the Message Reply Enhancement
feature, see the Norstar Modular ICS 4.0 Installer Guide.
1. Press
ƒ⁄.
2. On a telephone with a two-line display, press ADD. (This
step is not necessary on a telephone with a one-line
display.)
3. Enter the internal number of the person to whom you want
to send the message. The person’s display reads
Message for you.
p0881591.book Page 99 Wednesday, August 19, 1998 6:43 PM