Nortel Networks Modular ICS 4.0 - Manual (Page 153)

Programming Hunt Groups / 141
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
3. Press
‡¤‡fi°‡ (SCPLUS). The display shows
Terminals&Sets.
4. Press
‘ until the display shows System
prgrming.
5. Press
≠. The display shows Hunt groups.
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠. The display shows
Member DNs:.
9. Press
‘ until the display shows Mode.
10. Press CHANGE to set the mode: Sequential, Rotary,
Broadcast.
11. Press
® to exit or ‘ to continue programming.
Setting the hunt delay
This setting allows you to program the number of rings the
system permits at a Hunt Group set before moving on to the
next set in the Hunt Group.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press
ƒ••¤flfl‹›› (CONFIG).
The display shows Password:.
3. Press
‡¤‡fi°‡ (SCPLUS). The display shows
Terminals&Sets.
4. Press
‘ until the display shows System
prgrming.
5. Press
≠. The display shows Hunt groups.
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
p0881591.book Page 141 Wednesday, August 19, 1998 6:43 PM