Nortel Networks Modular ICS 4.0 - Manual (Page 15)

Getting started with Norstar / 3
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Before you start
Before you begin programming, plan what changes you want to
make. Record the changes in the
Norstar Programming Record so
that you have the information at hand. For example, if you are
going to program system speed dial numbers, fill out the page in
the
Norstar Programming Record so that you have all the numbers
and codes handy once you start programming.
What you’ll need to do programming
Programming is done using a telephone that can show two lines
of information on its display. Examples of telephones with two-
line displays are shown on page 4.
You need a programming overlay to show which buttons to press
when you are doing programming. See “The programming
overlay” on page 6.
When you use a telephone for programming, it is taken out of
service. This means it is unable to receive or make calls, and the
call forward features do not work. Do not use the main reception
telephone for programming because you may lose incoming
calls.
p0881591.book Page 3 Wednesday, August 19, 1998 6:43 PM