Nortel Networks Modular ICS 4.0 - Manual (Page 149)

Programming Hunt Groups / 137
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Norstar set can be in more than one Hunt Group but is
considered a member in each Hunt Group, increasing the total
number of members in the system.
There can be only one appearance of the same Hunt Group on
a set. Hunt Group DNs cannot be members of other Hunt
Groups. A DN can be associated with a member of a Hunt
Group and is called a member DN.
Consult your customer service representative to determine
your Hunt Group number range.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press
ƒ••¤flfl‹›› (CONFIG).
The display shows Password:.
3. Press
‡¤‡fi°‡ (SCPLUS). The display shows
Terminals&Sets.
4. Press
‘ until the display shows System
prgrming.
5. Press
≠. The display shows Hunt groups.
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠. The display shows
Member DNs:. (There
are no member DNs if none are programmed.)
9. Press
≠. The display shows the members for that
group.
10. Press ADD to add a member or press REMOVE to remove a
member from the group.
11. Press
® to exit or ‘ to continue programming.
p0881591.book Page 137 Wednesday, August 19, 1998 6:43 PM