Nortel Networks Modular ICS 4.0 - Manual (Page 155)

Programming Hunt Groups / 143
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠. The display shows
Member DNs:.
9. Press
‘ until the display shows If busy:.
10. Press CHANGE to set the mode: BusyTone, Overflow,
Queue.
11. Press
® to exit or ‘ to continue programming.
Programming the queue time-out
This setting allows you to program the number of seconds a
call remains in the Hunt Group queue before it is routed to the
overflow position.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press
ƒ••¤flfl‹›› (CONFIG).
The display shows Password:.
3. Press
‡¤‡fi°‡ (SCPLUS). The display shows
Terminals&Sets.
4. Press
‘ until the display shows System
prgrming.
5. Press
≠. The display shows Hunt groups.
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠. The display shows
Member DNs:.
9. Press
‘ until the display shows Q Timeout:.
10. Press CHANGE to set the queue time-out: 15, 30, 45, 60,
120, 180.
11. Press
® to exit or ‘ to continue programming.
p0881591.book Page 143 Wednesday, August 19, 1998 6:43 PM