Moving members of a group, Assigning or unassigning lines to a group, Moving members of a group 138 – Nortel Networks Modular ICS 4.0 User Manual
Page 150: Assigning or unassigning lines to a group 138
138 / Programming Hunt Groups
Modular ICS 4.0 System Coordinator Guide
P0881591 Issue 01
Moving members of a group
Member order within a Hunt Group is important. The member
order determines how a call is routed through a Hunt Group.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press
ƒ••¤flfl‹›› (CONFIG).
The display shows Password:.
3. Press
‡¤‡fi°‡ (SCPLUS). The display shows
Terminals&Sets.
4. Press
‘ until the display shows System
prgrming.
5. Press
≠. The display shows Hunt groups.
6. Press
≠. The display shows
Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press
≠. The display shows
Member DNs:.
9. Press
≠. The display shows the members for that
group.
10. Press MOVE to move an existing member to another place
within the Hunt Group. The display shows the member
number followed by an arrow.
11. Enter the new position number for the extension.
12. Press
® to exit or ‘ to continue programming.
Assigning or unassigning lines to a group
Configure the prime set for a Hunt Group’s line to None to
avoid delayed ring transfer of external Hunt Group calls to the
prime set before the Hunt Group can receive the call.
A line can be assigned to only one group.
p0881591.book Page 138 Wednesday, August 19, 1998 6:43 PM