NComputing PC Expanion L120 - Manual (Page 57)

8-16
How to configure the PC Expanion.
Click the button in the startup screen on the PC Expanion. 1
7. How to connect to the specific host PC
automatically
Select the ‘TS Options’ tab, select ‘TS 2’ or ‘TS 3’, click the Disable> button and click the button. To connect to a
specified host computer automatically, there must be one host
computer on the list of the PC Expanion initial
screen. If ‘Autodetection’ is selected in the ‘TS Options’ screen,
select ‘Autodetection’, click the button to
unselect the option, and select either ‘TS 2’ or ‘TS 3’. 2
Type the address that you want to connect to the host PC in the
‘Terminal Server network address’ column. Then select the
‘Autoconnection Enable’ option. Refer to ‘3. How to check the IP
address setting of host Computer’ in Part 8. regarding the IP
address of specific host PC. Click the button. Then click the
button. The setup procedure is finished.
When the PC Expanion is rebooted, the PC Expanion attempts to
connect to the specific host PC after a few seconds. If the PC
Expanion is connected to the host PC, please check the IP address
of the specific host PC in the setup. 4
How to set up under the NCT-2000-XP console
Select
in
order to run the NCT-2000-XP
program. Go to the Settings (Local/LAN)>
Select
and then
select the specific PC Expanion
in the “UTMA/UTSA list” and
double-click it.
1