NComputing PC Expanion L120 - Manual (Page 50)

8-9
The user can check the IP address of the host PC under DOS
environment.
or Type ‘cmd’ and then
click the button. Then type ‘ipconfig’ command and click the
key. You can see the IP address of the host PC.
In Windows XP, you can easily confirm the IP address settings with
or without opening a DOS command prompt window. In Step 2 of
the Settings in Windows XP, if you select the tab, you
can view the current IP address settings.
Note
Connecting to the network using a cable or DSL router (DHCP function of more than 100Mbps with switching )
Refer to ‘2. How to check the IP address setting of PC Expanion’ in
Part 8., Then set the IP address of the PC Expanion. 1
To set the IP address of a host computer refer to ‘3. Setting and
Confirming the IP Address of a Host Computer.’ The IP address of a
host computer and the address of the PC Expanion must be in the
same sub-network. This means that the first 3 among the 4 numbers
of the IP addresses must be the same. For example, if the IP address of
a host computer is 192.168.0.1, then the PC Expanion must have an IP
address starting with 192.168.0. If one of the first 3 numbers of the IP
addresses is different, they are not in the same sub-network. To
connect to a computer outside of the same sub-network, specify a
host computer to connect to and refer to ‘6. Connecting a Specific
Host Computer.’ 2
Click the ‘Connection to’ arrow in the PC Expanion initial screen and
select a host computer from the list. If ‘Autodetection’ is selected in
the
of the PC Expanion, up to 8 host
computers within the same sub-network of the NCT-2000-XP
application will be automatically found and listed. Automatically
found host computer names are marked by the ‘*’ symbol in front of
them. If ‘Autodetection’ is not selected in
and only ‘TS 2’ or ‘TS 3’ is selected, ‘TS 2’ or ‘TS 3’
appears in the list without the ‘*’ symbol.
3
4. How to connect between the PC Expanion and the
host PC using network equipment.