NEC UNIVERGE NEAX 2000 IPS - Manual (Page 29)

Chapter 1 Introduction
UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide Page 1-23
Issue 6
IP Remote Network Capacity
Total System Capacity (Main plus Remote)
Item Capacity
LT Ports 1020
AP Ports 256
Analog Single Line Tel. + Dterm 980
IP PAD (No. of Channel) 256
Dterm IP/Dterm IP INASET (PTP Connection) 952
Dterm PS
512
Cell Station (CS) / Zone Transceiver (ZT) 128
ISDN Station 128
Central Office Trunk (Lines) 256
Tie Line Trunk (Lines) 2W/4W E&M 192
CCIS Trunk (Peer to Peer Connection) 127
DTI/CCIS Digital Link 1.5M/2M DTI: 10/CCIS: 8 Links
1.5M/2M (PRT) 8
ISDN
4BRT (card) 24
IP Trunk 8
PFT Connections 64
3-Party Conference Max. 16 conference groups
6-Party Max. 4 conference groups
6-/10-Party Conference
10-Party Max. 2 conference groups
32-Party Conference Max. 8 conference groups
Built-in Router 1 per Site
DTMF Sender/Receiver Max. 32 circuits
Attendant Consoles 8
Attendant Terminal (Dterm ATT Position) Max. 8 sets
SMDR Interface
Max. 2 Interface ports (RS232)
Max 1 interface port (IP) per system
PMS Interface
Max. 1 Interface port (RS232)
Max 1 interface port (IP) per system
ACD / MIS or OAI Interface Max. 1 interface port
Remote PIM over IP
Note
Up to 30 (depending on network)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization Code / Forced Account Code / Remote
Access to System(DISA)Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1024
Note: Remote PIM networks using the IPS DML as the main are not supported.