NEC UNIVERGE NEAX 2000 IPS - Manual (Page 199)

Chapter 10 System Input/Output (I/O) Interfaces
UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide Page 10-3
Issue 6
MP built-in SMDR on IP
ITEM Specifications
Physical Layer Ethernet
Connection Layer The Ethernet packet format complies with the DIX standard
TCP/IP Protocol ARP, IP, ICMP, UDP, TCP
Socket Interface Complies with 4.3 BSD socket interface
Transport Protocol TCP stream type protocol
Application Port Number 60010 (fixed)
Number of Connections 1
Client/Server Client: SMDR terminal
Server: PBX
Transmission Code 7-bit ASCII code
Quasi-normal Restriction Condition 1. When connection is closed
2. Status monitoring text
Note 1: The MP card in main site communicates with the SMDR terminal. Therefore, in the communication
settings at SMDR terminal side, set the IP address to connected to the address specified by office data
(CM0B Y=00>00 or CM0B Y=02>03), and application port number shown in the above table.
Note 2: One message is sent each time a request is received from SMDR terminal.
Combinations between SMDR and SMDR Output Format
SMDR
2400 IMS
Format
Extended
2400 IMS
Format
1400 IMS
Format
SMDR with AP00
(PN-AP00-B with MRC-C program)
X — X
SMDR with AP00
(PN-AP00-B with MRC-F program
)
X X —
MP built-in SMDR on RS-232C
X X —
MP built-in SMDR on IP
X X —
X: Available —: Not available
Combinations available at the same time
SMDR Pattern A Pattern B Pattern C Pattern D Pattern E
SMDR with AP00
(PN-AP00-B with MRC-C program)
— — — — X
SMDR with AP00
(PN-AP00-B with MRC-F program
)
— X — X —
MP built-in SMDR on RS-232C
X X — — —
MP built-in SMDR on IP
— — X X —
X: Available —: Not available