NEC Express 5800/320Lb - Manual (Page 95)

4-11
Advanced
Select "Advanced" on the Advanced menu to display the following screen.
See the table below for setup options on the screen.
Option Parameter Description Your Setting
Boot-time
Diagnostic Screen [Disabled]
Enabled Specify whether to display the Power On
Self-Test (POST) screen at start-up. If
"Disabled" is selected, the NEC logo
appears while POST is in progress. (To
display POST check results, press Esc.)
If "RomPilot Support" is set to "Enabled" or
"Console Redirection" is set, this option is
unconditionally set to "Enabled".
RomPilot Support [Disabled]
Enabled Enable or disable the RomPilot (the remote
console and remote drive features during
OS start-up). If this option is set to
"Enabled", "Boot-time Diagnostic Screen" is
unconditionally set to "Enabled".
Post Error Pause [Enabled]
Disabled Specify whether to stop POST at the end of
POST when an error occurs during POST.
[ ]: Factory-set
TIPS: "RomPilot" is a BIOS feature for communications with the NEC Management
Workstation Application (NEC MWA). To use the NEC MWA for management of the server,
select "Enabled" for "RomPilot Support.” Use of the RomPilot features requires setups for
the NEC MWA.
Select Item
Select Menu
Boot-time Diagnostic Screen:
RomPilot Support:
POST Error Pause:
Display the diagnostic
screen during POST
instead of the Logo.
The boot-time diagnostic
screen is redirection
or rompilot is enabled.
Item Specific Help Advanced
[Disabled]
[Disabled]
[Enabled]
Phoenix BIOS Setup Utility
Advanced
F1 Help -/+ Change Values F9 Setup Defaults
F10 Save Changes & Exit Sub-Menu Enter Select Esc Exit
Select Item
Select Menu