NEC Express 5800/320Lb - Manual (Page 286)

8-44
Setup of Optional PCI Board
IMPORTANT:
To enable the fault-tolerant feature of the optional device, the identical devices must be
installed to the same slots in groups 1 and 2, respectively.
A video board is already installed to slot #1 as standard configuration. This board may not be
removed or replaced with any other board.
Change the BIOS settings. For some optional PCI boards you may need to start up the BIOS
setup utility to change the [Boot Monitoring Time-out Period] configuration in [Advanced] –
[Monitoring Configuration]. For more details, see page 4-15.
For supported connection devices, contact your sales agent.
N8804-001P1 100BASE-TX Adapter Set
IMPORTANT: Note the following about this product:
For LAN cable’s connector, use the RJ-45 connector which is compliant with IEC8877 standard.
Using a different connector may make it difficult to remove the connector.
Slots to install the board
PCI slot
Group 1 Group 2 N code Name
#1 #2 #3 #1 #2 #3
Remarks
N8804-001P1 100BASE-TX Adapter
Set
– √ √ – √ √
√: Can be installed. –: Cannot be installed.
Installation of driver
The NEC Express5800/ft series duplicates one or two pairs of 100BASE-TX adapter sets
(N8804-001P1) before using.
After installing Operating System, install the drivers in the following procedure and make
dual settings of the PCI board.
TIPS: To perform this procedure, you have to log on the system as an Administrator or
a member of the Administrators group.
After installing the OS, follow the steps below to install a driver and establish a dual
configuration: