NEC Express 5800/320Lb - Manual (Page 87)

4-3
Starting SETUP Utility
Powering on the server starts POST (Power On Self-Test) and displays its check results. If the NEC
logo is displayed, press Esc.
After a few seconds, either of the following messages appears at bottom left on the screen
depending on your system configuration.
Press to enter SETUP
Press to enter SETUP, Press to Network
You may see either of the following messages at bottom left on the screen when POST terminates.
Press to resume, to SETUP
Press to resume, SETUP, Network
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears.
Enter the password.
Enter password:[ ]
Up to three password entries will be accepted. If you fail to enter the password correctly for three
consecutive times, the server halts. (You can no longer proceed.) Power off the server.
TIPS: The server is provided with two levels of password: Supervisor and User. With the
Supervisor password, you can view and change all system configurations. With the User
password, the system configurations you can view or change are limited.