NEC Express 5800/320Lb - Manual (Page 130)

5-2
NEC EXPRESSBUILDER
The NEC EXPRESSBUILDER, integrated setup software, can automatically detect the hardware
connected to an NEC Express5800/ft series machine to advance the processing. The hardware
subject to setup with the NEC EXPRESSBUILDER should have the same configuration as that for
operation.
Start Menu
The NEC EXPRESSBUILDER provides three procedures to start the server as described below. The
menus and items appearing on the screen vary depending on the procedures.
Booting (starting) the server from NEC EXPRESSBUILDER CD-ROM
For the procedure, insert the NEC
EXPRESSBUILDER CD-ROM into the
CD-ROM drive of the NEC Express5800/ft series
and start the NEC Express5800/ft series from the
system in the NEC EXPRESSBUILDER. When
the NEC Express5800/ft series is started by using
this procedure, the NEC EXPRESSBUILDER top
menu shown on the right appears.
Perform the NEC Express5800/ft series setup
from this menu.
IMPORTANT: Don’t use this CD-ROM on computers other than NEC Express5800/ft
series with which it is packaged (including other NEC Express5800 models). Otherwise,
a breakdown may result.
See "NEC EXPRESSBUILDER Top Menu" for details.
Booting (starting) the server from
NEC EXPRESSBUILDER CD-ROM in
the consoleless state
If the NEC EXPRESSBUILDER is
started from the CD-ROM drive in the
server with the keyboard, mouse, and/or
display unit not connected to the server,
the NEC EXPRESSBUILDER Tools
Menu shown on the right appears on the
screen of the management computer (PC)
connected to the server through LAN or
COM (serial port).
Then operate the server remotely from the management PC by using the items in the menu.