NEC Express 5800/320Lb - Manual (Page 118)

4-34
SCSI Bus Settings
If you put the cursor on "SCSI Bus Settings" with keyboard cursors ( ↓ and ↑) in the "Configuration
Settings" menu and press Enter, the screen for setting the information on the SCSI bus of the host
adapter appears.
The table below shows the parameters of the setting items and their factory settings.
IMPORTANT: The settings can be made for each SCSI bus.
Parameter Submenu item
SCSI Bus0 SCSI Bus1
Description
SCSI Bus SCSI ID 0, 1, 2, 3, 4, 5, 6,
[7], 8, 9, 10, 11,
12, 13, 14, 15
0, 1, 2, 3, 4, 5, 6,
[7], 8, 9, 10, 11,
12, 13, 14, 15 Select the SCSI ID given to SCSI
bus.
SCSI Bus Reset [Enabled]
Disabled [Enabled]
Disabled Make the reset valid or invalid in
SCSI buses.
SCSI Bus Reset
Delay 0, 1, 2, 3, 4, [5],
6, 7, 8, 9, 10, 11,
12, 13, 14, 15 0, 1, 2, 3, 4, [5],
6, 7, 8, 9, 10, 11,
12, 13, 14, 15 Leave this item as factory-set.
SCSI Bus
Termination Auto
High only
Disabled
[Enabled] [Auto]
High only
Disabled
Enabled Set the termination resistance of
SCSI bus.
[ ]: Factory-set
Autoconfigure SCSI Device
If you put the cursor on "Autoconfigure SCSI Device" with keyboard cursors ( ↓ and ↑) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the device
connected to the host adapter appears.
The parameters of the setting items and their factory settings are the same as those shown in the
table for "SCSI Device Settings."
IMPORTANT:
The settings can be made for each SCSI bus and SCSI ID. Check the SCSI ID of the target
device before changing the settings.
The factory settings are the same for both SCSI bus 0 and SCSI bus 1.
The following items can be changed by setting "Adapter Configuration" in "Autoconfigure
SCSI Device" to "Manual."
– Enable Device
– Enable LUNs
– Negotiate Wide
– Negotiate Sync
– Tagged Queuing
– Sync Offset
– Sync Period
– Exec Throttle