Kodak DCS300 - Manual (Page 202)

11-4
If you remove the antialiasing filter and don’t re-install it, you should store it in a clean,
dust-free space.
3 Carefully unscrew the screw at
the bottom of the antialiasing
filter bracket using a jewelers
screwdriver (Phillips #00).
4 Carefully remove the filter
bracket from the camera.
5 Gently blow off the dust using
commercially available “canned
air.” If the antialiasing filter is
still dirty, please contact your
dealer or service representative.
6 To re-install: place the filter
bracket tabs into the upper two
notches on the camera lens
opening, and secure the screw at
the bottom.
7 Replace the lens.
Refer to “Mounting the Lens”
on page 1-19.
M
AF