Samsung FLEX-MUXONENAND KFN8GH6Q4M - Manual (Page 95)

Flex-MuxOneNAND4G(KFM4GH6Q4M-DEBx)
- 95 -
FLASH MEMORY
Flex-MuxOneNAND8G(KFN8GH6Q4M-DEBx)
Flex-MuxOneNAND16G(KFKAGH6Q4M-DEBx)
3.13.2 OTP Block Program Operation
An OTP Block Program Operation accesses the OTP area and programs content from the DataRAM on-chip buffer to the designated page(s)
of the OTP.
A memory location in the OTP area can be programmed only one time (no erase operation permitted).
The OTP area is programmed using the same sequence as normal program operation after being accessed by the command (see section 3.9
for more information).
Programming the OTP Area
• Issue the OTP Access Command
• Write data into the DataRAM (data can be input at anytime between the "Start" and "Write Program commands".
• Issue a Flash Block Address (FBA) which is 0000h of NAND Flash Array address map.
• Issue a Program command to program the data from the DataRAM into the OTP
• When the OTP Block programming is complete,
do a Cold-, Warm-, Hot-, NAND Flash Core Reset to exit the OTP Access mode.